Marley MX75 Fills Hanging Film Type With SGS Certification
MAH series is a hanging film type cooling tower fill which spreads the water into a thin film, flowing over large vertical surfaces, promoting maximum exposure to air flow. This infill incorporates highly efficient cellular drift eliminators, integrally molded within the fill sheets. Width is available from 760mm to 1520mm to satisfy different cooling towers request.
Specification
| Module Length (Max) |
mm |
3708 |
| Module Width |
mm |
760/915/1220/1320/1520 |
| Module Depth |
mm |
- |
| Flute Height |
mm |
19 |
| Flute Corrugation Angle |
degrees |
- |
| Surface Area |
m2/m3 |
150 |
| Sheet Thickness - Before Forming |
mm |
0.38 |
| Sheet Thickness - After Forming |
mm |
0.35 |
| Max. application temp. (short time) - PVC |
°C |
55 |
| Max.operating temp. (short time) - High temp |
°C |
80 |
| Customized size and thickness available for special request. Contact Newin for details! |
Packing and Loading: LCL shipment: by plywood pallet/case/carton, FCL shipment: by container
Trade Terms: EXW, FOB, CFR,CIF, DDU.
Payment term: T/T, L/C, West Union
Minimum Order Quantity: 1000pcs
STRUCTURE & INSTALLATION DRAWING
Newin supply structure & installation drawing advice with jobsite storage advice and quality control report along with shipment to make attention to customers when they receive the materials. OEM or special mold design also available on request.
APPLICATION & USAGE
Newin MAH Film Fill is applicable for Marley cooling tower series of
NC, NX,QUADRA FLOW, AQUATOWER, AV, 600 Field Erected, with SGS test in ASTM Standards to keep high quality infill to get the high efficienty of the cooling tower. Inform us the tower model or size, we will estimate the Nos of sheets needed for your cooling tower replacing.
APPLICABLE COMMERCIAL STANDARDS
Sheets material is strictly followed below SGS test with ASTM standards. Each property or all properties as below tested by your products are also vailable on request.
| Property |
Test Method |
Values |
| Specific Gravity |
ASTM D792-13 Method B |
1.426g/cm3 |
| Oxygen Index |
ASTM D2863-13 |
34.50% |
| Tear Strength |
ASTM D1004-13 |
X direction |
111N |
| Y direction |
121N |
| Tensible Test |
ASTM D 882-12 |
Tensile Strength |
X direction |
51.1MPa |
| Y direction |
45.3Mpa |
| Elongation at Break |
X direction |
87% |
| Y direction |
56% |
| Values shown above based on SGS Test No.: GZIN1708039662PS by Newin |
| Statements and methods presented are based upon the best available information and practices known to Newin. Conditions of use may vary and are beyond control, the user should undertake sufficient tests to determine the suitability for any intended use of the material. |
MAH REFERENCE PROJECT CASE
Audited Supplier 
){kind=link}
){kind=link}