LAH Series Cross Flow Film Fills/Filler
Newin LAH series cross flow fills is PVC or PP sheet material with the advanced technical, long lifetime, low resistance, light weight. During the service, the fill can increase the water flow process. It is widely used in square cooling tower. Good heat dissipation, large flux, low resistance, uniform distribution, good water distribution, no clogging, no agglomeration, large specific surface area, improve oxygen transfer rate and utilization rate.
FEATURES
Adopts the design of thin film, to increase the cooling area and reduce the wind resistance.
Sharp horizontal corrugations allow even water redistribution on the sheet and water rotation for good contact with air. The offset flute design allows vertical rotation of air with limited pressure drop.
With advanced PVC plastic material after vacuum forming, fabrication and stable quality, not easy to brittle characteristics.
Filler used plate agglutination complete set type, each packing pills, all keeps the same spacing between airflow through.
PROPERTIES
With different request in LAH film fill, like length and width, materials or thickness, etc, please inform us your detailed request to get correct solution and offer. Newin could cover all customer requirements. Fill media in flame retardant or anti-bacterial execution are also available on request.
| Module Length (Max) |
mm |
1600 |
| Module Width |
mm |
750/1000 |
| Module Depth |
mm |
- |
| Flute Height |
mm |
20 |
| Flute Corrugation Angle |
degrees |
- |
| Surface Area |
m2/m3 |
147 |
| Sheet Thickness - Before Forming |
mm |
0.32 |
| Sheet Thickness - After Forming |
mm |
0.28 |
| Max. application temp. (short time) - PVC |
°C |
60 |
| Max.operating temp. (short time) - PP |
°C |
80 |
| Customized size and thickness available for special request. Contact Newin for details! |
STRUCTURE & INSTALLATION DRAWING
Newin supply structure & installtion drawing advice with jobsite storage advice and quality control report along with shipment to make attention to customers when they receive the materals. OEM or special mold design also available on request.
APPLICATION & USAGE
Newin LAH Film Fill is applicable for Liangchi cooling tower, with SGS test in ASTM Standards to keep high quality infill to get the high efficiency of the cooling tower. Inform us the tower model or size, we will estimate the Nos of sheets needed for your cooling tower replacing.
APPLICABLE COMMERCIAL STANDARDS
Sheets material is strictly followed below SGS test with ASTM standards. Each property or all properties as below tested by your products are also vailable on request.
| Property |
Test Method |
Values |
| Specific Gravity |
ASTM D792-13 Method B |
1.426g/cm3 |
| Oxygen Index |
ASTM D2863-13 |
34.50% |
| Tear Strength |
ASTM D1004-13 |
X direction |
111N |
| Y direction |
121N |
| Tensible Test |
ASTM D 882-12 |
Tensile Strength |
X direction |
51.1MPa |
| Y direction |
45.3Mpa |
| Elongation at Break |
X direction |
87% |
| Y direction |
56% |
| Values shown above based on SGS Test No.: GZIN1708039662PS by Newin |
| Statements and methods presented are based upon the best available information and practices known to Newin. Conditions of use may vary and are beyond control, the user should undertake sufficient tests to determine the suitability for any intended use of the material. |
FILED DATA FOR CROSS FLOW FILM FILL REPLACEMENT
Fill in below measurements data for your maintenance cooling tower or reparing projects demand quality and reliability, count on Newin, site visit or maintenance service, engineered to fit the cooling tower fills or components.
Audited Supplier 
){kind=link}
){kind=link}